ARIES
Manual Vinyl (PVC) Hot Liquid Profile Bending
Machine
|
|
ARIES
Manual Vinyl (PVC) Profile Bending Machine
The manual vinyl (PVC) profile-bending machine is used
for bending vinyl profiles to form an arch. When
required, a tail of 100 mm (4") in length may be allowed
to facilitate the welding procedure.
The Basic Components Which Form the Machine
1-Work Bench
2-Bending Moulds, Interior Spades, Distance Gauges
3-Heater
4-Compass
5-Compass Lengthening
6-Traction Apparatus
7-Immersion Gravities
8-Washing Tank
9-Draining Tank
10-Front Trestle Bracket
11-Rear Trestle Bracket
Working bench
15 exterior and 15 interior mould holder aluminum set
squares are inserted into the T-channels on the work
bench to support the bending moulds. The bending moulds
may be fixed to a desired diameter by using the aluminum
set squares. The top spandrel may move to both sides,
the left or the right, approx. 400 mm (16") with an aid
of a gear.
Bending moulds
These are heat resistant and flexible. The Interior
spades prevents the profile from deteriorating when
working at small diameters. The internal spades are
formed from a material similar to the moulds. Distance
gauges and aluminum mould holders can bend glass bars
without adjusting.
Heater
The heater is made from stainless steel, and has a 2-mm
thickness. The 10 kW power allow the heater to supply
sufficient temperature for the oil. The temperature
control is achieved by digital thermometers and
thermostats. It is insulated by a 30 mm thick glass
wool, which is covered by stainless steel. This
insulation provides a 25% reduction in power use. The
steam emission equipment provides the steam coming from
the heater, and does not permit its diffusion into the
working area. The aspirator may work with a low capacity
when the lids are closed. When the lids are opened, it
may work at a higher capacity to emit the steam to the
exterior environment. The heater has a switch box
containing the necessary equipment to operate as needed.
The heater level may be adjusted with respect to the
workbench. The round rollers in the profile resting pan
prevent the heated profiles to rubb on the pan.
Compass
The compass is used to adjust the mould bender holders
to any desired diameter. It has 2 rulers with 1100 mm
(43") and a 3100 mm (122") in length.
Compass lengthening bar
The central compass lengthening bar is used for radiuses
over 950 mm (37"). It may be assembled to the working
bench. It may also work as a centering device for the
traction apparatus.
Traction apparatus
The traction apparatus may be used to facilitate the
procedure of pulling the heated profiles including its
padding materials into the bending mould.
Immersion gravities (2 pieces)
This unit is used to immerse the heated profile with
padding into the oil. They are stainless steel.
Washing tank
The washing tank is made from stainless with 1.5 mm
thickness, and used to wash the bent profiles.
Draining tanks
These are used to drain the oil remaining inside the
profiles. These are 2 pieces and are manufactured from
stainless steel. This oil is discharged back to the
heater tank to re-use.
Front trestle bracket
This is used in order to prevent any deterioration of
the exterior parts of the bending mould that hangs
loosely from the sides of the working bench.
Rear trestle bracket
This part allows the heated profile including its
interior padding to be adjusted to the level of work
bench.
 |
|
Technical
features, design and specifications are subject to
change without prior notice |
|
|
